5 comments

Add a comment…

Sign in

prestine

Your email address

Check!

invalid email

(thinking…)

Reset

or sign in with

• 
• 

UserVoice password

Forgot password?

Create a password

Your name

I agree to the terms of service

Signed in as (Sign out)

Close

Close

Post comment Submitting...

• Steve Lafferty commented  ·  February 24, 2011 1:49 p.m.  ·  Flag as inappropriateFlag as inappropriate  ·  Delete

  I would also like to see the RED handle 802.1Q tagged packets (VLANs). I don't necessarily need to tag the physical port on the RED but I would like to see the RED pass these packets through to the ASG so I can handle appropriately. Otherwise I need 1 RED for each VLAN that I need to handle.

• maygyver commented  ·  February 18, 2011 10:39 a.m.  ·  Flag as inappropriateFlag as inappropriate  ·  Delete

  Your Switchport Must be configured with vlans tagged to it. Let's say your Interface has Vlan 12,13,205 , so the Switchport Must have at least, 12,13,205 tagged or all vlans tagged( might called Trunk port)

• maygyver commented  ·  December 1, 2010 1:07 p.m.  ·  Flag as inappropriateFlag as inappropriate  ·  Delete

  just setup vlan Interfaces on the Red physikal Interface. Setup Switch port connected to Red with tagged Ports for vlans.

• Jason Mougeot commented  ·  December 1, 2010 10:20 a.m.  ·  Flag as inappropriateFlag as inappropriate  ·  Delete

  I tried and doesn't seem to work...how have you done it. the asg will allow you to create ethernet vlans but does not chat to my switch.

• maygyver commented  ·  November 12, 2010 1:59 a.m.  ·  Flag as inappropriateFlag as inappropriate  ·  Delete

  This is possible. But You have to have a VLAN Switch behind the RED.